@rodneytay3545

Fantastic.  You know the old saying, "you don't know what you don't know" and it was definitely true in my case:  I looked at my pillow blocks for hours trying to figure this out - and thinking that there was no way to press the bearings in without the cast iron pillow block housing exploding.  I'm convinced your info just saved me no end of grief.  Thank you!

@farnorth13

this video just saved us so much work....we didn't have any idea how to replace a similar bearing in a similar flange ..had no idea what those 2 grooves were for....went in smooth as could be for us once we knew the proper procedure Thank you !

@jryer1

Excellent instructional video. Thank you!

@kruppratte218

Thanks, I was wondering about that, I ended up using a handle off of a Broken Chain Disconnector, instead of a pry bar, but before I seen this video, I was going to beat it in with a hammer, I just installed my first bearing in a housing with no bearing in it, needed it as an Idle Gear shaft or a Slave gear shaft, I'm basically teaching myself Mechanical Engineering, videos like this are a huge help, saves a ton of money, time & effort, now just need to grease it & get a nipple cover I guess.

@Mijanur96

Thanks...I learn how to open pilo block bearing from this video...

@electricaldrawing4067

Thanks for ur highly co-operation.

@g.zoltan

That design is really smart, strictly keeps the bearing in while it can still be removed, but does that also mean that the bearing can rotate in the housing? So when using this type of bearing unit, I need 2 of these to have a fixed axis dierction?

@kayacox5190

This was super helpful thank you

@WilleJamesHuff

This video helped a lot. Thanks!

@MarkIrwin561

Thank you, SKF ❤

@1think19

What about if the shaft doesn't come out like that how do u remove the bearing from the shaft when it's been there for ever

@telefoniafalsetta1982

Is this a self aligning bearing?

@lustatus

you gave it two pump of grease ; is that enough?

@brentbarnhart5827

Did you MAKE SURE that was made by Allen?  or was it just a Hex Head?   LOL   (Sorry, it took me decades to change my terminology.)

@PP.EKOTECH

GOOD  JOB ! :)

@coltx64

what can i do if I don't have the grease machine you use? and what can I do to make the bearings roll easier? I have two UCP201 - UCP212

@김종민-h2u6h

교육용 영상인가요? 샤프트 공차가 ㅎㅎ 일주일에 한번 문제 생길듯

@aziznoureddine4705

Hello. Does it affect water and cause it to break or not

@aziznoureddine4705

Hi. Does the water affect the roller or not.

@mustafacalcuttawala4581

Is there any way to remove the seal of the adapter and expose the balls for cleaning ?