@rabmc
Just purchased this, sorted a lot of surface rust on my bmw e46 m3 underside with wire brushes and drill bits and pressure wash, just waiting on delivery. Possibly do a video of the process.
@TheToby3333
On a motorhome, would it be beneficial to spray the underneath wooden ply lined floor?
@Stanleytone-04
Hi there, I treated my vehicle with Lanoguard about 6 weeks ago and also sprayed the exhaust. For a good couple of weeks I expected and had a burning smell once the exhaust was hot. By and large the smell has gone but sometimes I can still smell whatbI believe is the lanoguard remaining on the exhaust. Is this normal? I do not think it is anything else as I never had the smell prior to applying the Lanoguard. Thankyou.
@johnrestel2994
Is there anything I shouldn’t spray with Lanoguard? Obviously the brakes are a no go but is there anything else to avoid? I’m a bit worried about damaging rubber boots, bushings, brake lines, plastic fuel tanks and suspension parts as some other products tell you to avoid those areas.
@Stoplight123
Can it be used 😅n hybrid cars
@andyweb7779
Can I buy massive amounts of shares in your company? Cause you guys are gonna be rich ! lol
@khalilrazak6486
Do I need to take off the front skid plate on my landrover discovery 4 or is that a bad idea also shall I leave my spare wheel on, I looked at your video regarding that nice discovery 4 that you lanoguarded and I'm sure you did not take off the skid plate or the spare wheel. Thanks
@steveelkins52
If it needs doing every year, then surely old engine oil/ diesel 50/50 mix will do the job, such as used by the military?
@alanaitcheson9403
My Meriva A 2007 has mild undercarriage corrosion, it's past its MOT so it's not dangerous, but will Lanoguard be of any use to stop the corrosion getting any worse?
@louiechidwick6034
Is it best to cover brake discs / calipers before spraying?
@fatfreddyscoat7564
Would there be a problem in treating the rust with phosphoric acid first and then spraying that (when dry) with Lanoguard?
@stevenedwards2162
Have you any outlets that might do this undersealing job professionally for the customer , if not might be a good opening for a good business investment , I personally would pay to get this job done instead of clambering underneath the vehicle on ramps and car Jack's.
@olitonottero7620
Is it safe to add graphite Powder to lanoguard to make it Dark Grey, Or will this interfere with the products rust preventing properties?
@akaski777
Guessing Lanolin
@fireryfurnace
Do i need to remove the lanoguard if it has a layer of dust over it before applying a topup coat, also putting it in the chassis rails do i need to blow them out with compressed air first, and what about subsequent dust build up in the chassis rails after applying the lanoguard
@Truthteller886